Used motorbike inspection checklist: what to check before you buy or swap
A motorbike-specific checklist: crash damage on the frame and forks, chain and sprockets, tyres and their date codes, brakes, service history and valve checks, electrics, a cold start and a sensible test ride.
By the WYG team · 9 min read · Last reviewed 11 November 2026
Why a bike needs its own checklist
A motorbike has nowhere to hide. The frame, forks, chain, tyres and engine are all in plain sight, and a bike that has been dropped, crashed or neglected usually shows it if you know where to look. The checks below take about half an hour and work for a private sale or a swap. Do them in daylight, with the engine cold, and bring a torch.
Start with the paperwork and the numbers
- The VIN or chassis number is normally stamped on the frame near the steering head. It should match the registration papers and the number in the advert.
- The engine number, normally on the crankcase, is worth checking against the paperwork too where your state or country records it.
- Ask who owns it. The name on the papers should be the person you are dealing with.
- Ask for the service book and the invoices, not just a stamp.
Crash and drop signs
Almost every bike has been dropped at a standstill once, and that is not a deal breaker. A real crash is different, because it can bend the frame or forks in ways that are hard to see. Look for:
- Scraped or ground-down bar ends, brake and clutch levers, footpegs, gear lever, mirrors and engine case covers.
- Fresh or mismatched paint, new plastics next to old ones, and fairing screws that look rounded or different from the rest.
- Forks that do not look parallel, a handlebar that is not centred when the front wheel points straight ahead, or a front wheel that does not sit in the middle of the forks.
- A bike that pulls to one side when you let it roll in a straight line, or a rear wheel that does not follow the front.
- Cracked, dented or re-welded frame sections, particularly around the steering head and the swingarm mounts. Be wary of fresh paint or filler in those places.
Forks, steering and suspension
- Oil on the fork legs means a leaking seal, which is a small repair on its own but should be priced in. Pitted or rusty fork tubes (the shiny inner part) tear new seals, so look closely.
- Hold the front brake and push the forks down a few times. They should move smoothly and come back without clunking.
- With the front wheel off the ground or the bike on a stand, rock the handlebar and the forks. Any play or clunk at the steering head means worn bearings.
- Grip the rear wheel at the top and rock it side to side. Movement in the swingarm bearings or the linkage is another price point.
- Check the rear shock for oil leaks and for a rear end that sits very low or bounces.
Chain and sprockets
On a chain-driven bike the chain and both sprockets are a wear set and are usually replaced together. A worn set is a sign of how the bike was looked after, and a typical replacement is a modest but real cost.
- Look at the sprocket teeth. Teeth that are hooked or pointed like a shark fin are worn out.
- Pull the chain gently away from the back of the rear sprocket. If it lifts a long way, so that you can see through the gap, it is stretched.
- Rotate the wheel and watch the chain for tight spots, stiff links or rust. A chain that is dry and rusty has not been cared for.
- A chain that is far too slack or far too tight has been adjusted by someone who was not paying attention.
- Shaft and belt drive bikes do not have this wear, but check for oil leaks at the final drive and for cracks or fraying on a belt.
Tyres and wheels
- Look for the date code on the sidewall: four digits, the first two being the week and the last two the year, so 2319 is the 23rd week of 2019. Rubber hardens with age, and many riders and tyre makers advise replacing tyres that are several years old even if the tread looks fine.
- Look for cracks in the sidewalls, flat spots down the middle of the rear tyre, uneven wear, and tread near the wear indicators.
- Check the wheels for dents, cracks or a bent rim. Spin each wheel and watch for wobble. Spoked wheels should have no loose or missing spokes.
- Mismatched brands or very cheap tyres can be a hint of how much was spent on the bike.
Brakes
- Look at the pads through the caliper. Very thin pads are a small, immediate cost.
- Look at the discs. A deep lip on the outer edge, deep grooves or a blue tinge from heat are bad signs.
- Brake fluid should be clear or light amber. Dark, dirty fluid is overdue for a change.
- The levers should feel firm. A soft or spongy lever can mean air in the system, old fluid or a failing seal.
- On a bike with ABS, the ABS warning light should come on at start-up and go out soon after you move off.
Service history and valve checks
Service intervals for bikes are set by the maker, in distance and in time, and they differ a lot between models. Oil and filter changes are frequent. Valve clearance checks are a bigger job on many engines and some models need them at long intervals while others need them at much shorter ones. Ask:
- When was the last valve clearance check or service, and who did it?
- When were the coolant, brake fluid and fork oil last changed?
- When were the spark plugs and air filter last replaced?
- Does the maker require a timing belt, a cam chain tensioner or some other part on a set schedule for this engine? Our guides on Ducati belts and Harley-Davidson Twin Cam tensioners explain two well known cases.
- Are there invoices that show the work was actually done?
Start it cold
Ask for the engine to be started cold, meaning it has not been run that day. A warm engine hides starting problems, rattles and smoke.
- It should start within a few seconds and settle to a steady idle.
- Listen for rattles that fade as the engine warms, knocking, or a ticking that is louder than normal for the model.
- A little white vapour that clears is normal. Blue smoke suggests oil is burning, and thick white smoke that does not clear can mean coolant is getting in.
- Check under the bike for oil, coolant or fuel leaks, and look at the engine cases for oil seeping from gaskets.
Electrics
- Test the headlight on low and high beam, brake light on both the lever and the pedal, indicators, horn and the dash lights.
- The battery should show roughly 12.6 volts at rest, and around 13.5 to 14.5 volts with the engine running above idle. A reading outside that range points to a charging problem. Our guide to stators and regulators covers it.
- Check the switch gear and the connectors for melted or burnt plastic.
The test ride
Test ride etiquette is simple and it protects both of you:
- Ask first, and expect the seller to ask to see your licence. They may ask to see your riding gear too, and many sellers will ask for a copy of your ID or a deposit that you get back.
- Wear proper gear: helmet, jacket, gloves, sturdy boots and trousers. Do not turn up in shorts and sandals.
- Check your own insurance. Many policies do not cover riding someone else's bike, so find out who is liable if it is dropped.
- Let the seller start and warm up the bike if they want, but make sure you also see it start cold.
- Keep it sensible. A test ride is not the time to wheelie, push the limits or go flat out.
- On the ride, check that it tracks straight, that the clutch and gearbox work smoothly with no false neutrals or missed gears, that the brakes pull it up in a straight line, and that nothing vibrates or rattles that should not.
Not sure about the price?
Once you know the exact model, year, variant and kilometres, Dyno can work out a value range, point out the known weak points for that bike and say how the asking price compares. It is a guide, not a formal valuation, so get a mechanic you trust to look at the bike before you pay.
Check a bike with Dyno
Paste a listing link and get a value range, reliability, known weak points and red flags in seconds. It handles cars and bikes. Three checks are free.
More guides
General information only, not legal, financial or mechanical advice. Prices, rules and what is known about a particular engine or gearbox differ by country, year and version and change over time, so confirm the details for the specific car or bike with an independent inspection and your local authority.
